How To Outsmart Your Boss On Peugeot 308 Key Fob
Peugeot 308 Key Fob Replacement
Peugeot's 308 might seem a little old but it's attractive. It might not be the most luxurious car in its class It's an Ford Focus or Volkswagen Golf will help you stay away from sloping surfaces - but it's a relaxing and civilised driving experience.
We get asked frequently at Coded Car Keys to replace peugeot key fobs. The following tips will assist whether the issue is constant or intermittent.
Water Damage
If you accidentally drop your key fob in a puddle or it is soaked while kayaking, canoeing, rafting or canyoning, the fob is likely to be damaged by water. The best method to prevent this from happening is to keep it in a dry bag when you're out in the open or engaging in activities in which the fob may be exposed to excessive amounts of water.
It is also important to ensure that the fob is completely dry prior to opening it and reusing it. If you notice any smells from the fob (such as industrial liquid or windshield washer fluid) This is a further indication that it's submerged.
A circuit board that's wet can cause the battery to discharge its energy or even explode. If you're able to fish the 308 key fob of the water in which it was stuck in then flip the button side down and shake out as much water as possible before opening the case. Once you have opened it, remove the battery and clean the circuit board with the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.
Other reasons your Peugeot 308 remote keyless entry system could not function include an empty coin battery or receiver module issues, signal interference, or an electronic chip malfunctioning. If none of these are the problem you can restart the system by removing the 12 volt battery from your car for 15 minutes.
Dead Coin Battery
Peugeot cars are equipped with a remote-start feature that allows the driver to start the car from a distance while warming up or cooling down the vehicle prior to getting in. This feature is very useful, especially in the cold winter months. However, there are times when the remote start system stops working due to a variety of reasons, including the battery of a coin that is dead.
A coin-shaped battery that is in the key fob can last for a period of between two and four years, depending on how often it is used and where it is purchased. The date of use is usually printed on the package or listed in the instruction manual.
If the key fob is no longer working after being exposed to clean tapwater, remove the battery and clean the electronic chip using a paper towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. If the key fob was exposed to soapy or salty water, it could have fried the chip. It is necessary to replace it.
If you are not sure the battery is defective You can test its voltage using a multimeter set to your car's voltage range. Connect it to the plus and minus terminals. If the voltage is lower than 12-13 volts, it is time to replace the battery. You can also reset your computer that is onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now start.
Faulty Receiver Module
If you don't see "Key Detected", it could be the receiver module malfunctioning. It's the part that sends an alarm to the car when the key fob is activated, which also acts as an immobiliser. It also stops it from starting until the correct key is used.
This could be caused by several reasons, such as water damage or just ageing. If the electronic chip inside your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was exposed it. In this situation, you'll have to take it off and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry, you can put the battery back in and try again.
If the issue continues to persist you're probably in need of a idea to seek out a local Peugeot specialist or locksmith. They can use an instrument for diagnosing to identify the issue and fix it.
Losing your Peugeot keys to your car is an emotional experience. However, a qualified auto locksmith can fix the issue in only a few minutes. They can program your car and cut a new, functioning key for you. Click here to find a locksmith near you.
Faulty Electronic Chip
The electronic chip that is in your Peugeot 308 key fob is an important part of the remote control system. If The KeyLab becomes damaged, your car might not start or you might receive a message that reads "anti-theft active". In this scenario, the only solution is to replace the key. Fortunately, auto locksmiths with experience can offer the service in the shortest amount of time.
The chip in your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other reasons. If your Peugeot key fob was exposed to soapy or dirty water, it must be cleaned as soon as possible. You can wipe the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. The battery should be allowed to completely dry.
Sometimes keys may stop working because of radio interference. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. It could be caused by problems with the environment or objects within the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you have this problem.
The Peugeot key fob 207/308 is extremely delicate and requires care. You shouldn't drop it or throw it around. If you lose it, try to locate it as quickly as possible. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a short period of time. Remove the negative cable before the positive.